Carbonit DUO-HP Basic (parallel)
Description
Carbonit DUO-HP Basic (parallel) under counter water filter
- With the parallel filter arrangement, both cartridges see the same water flow.
- Doubling of the max flow rate and retention capacity compared to e.g. VARIO-HP units.
- Set is suitable for the filtration of the entire cold water flow at the sink tap, aswell as for the water withdrawal via a separate discharge.
- The high-quality and massive base, made from polyoxymethylen, is manufactured entirely in Germany.
- No drilling: The filter unit can be located decently under the counter, avoiding any compromise on kitchen design.
- Cartridge replacement is comfortable and easy with the quick couplings.
Compatible filter cartridges
- The Carbonit DUO-HP Basic (parallel) set is delivered without filter cartridge.
- Compatible to all 9 3/4" filter cartridges. Please use two cartridges of the same type.
- To filter the entire water flow at the sink tap, the combined flow rate of the cartridges must be minimum 7 l/min.
- For the use of cartridges with reduced flow rate, we suggest water withdrawal via a separate sink tap or three-way sink tap.
- For hygienic reasons, we recommend replacement of the cartridges every 6 months (according to DIN 1988).
- Do not miss any cartridge replacement, apply for our non-binding and free of charge filter subscription service.
Installation
- The DUO-HP Basic (parallel) filter unit can be installed, without costly retrofitting, at any standard water connection in the kitchen or in the bathroom.
- Hoses and 3/8-inch fittings are enclosed in the set. As required, these can be extended.
- Optionally, you may install a separate sink tap for the filtered water: angle T-valve is included.
- Only to be used with cold water and must be protected against freezing.
Dimensions and other information on the Carbonit DUO-HP Basic (parallel)
Type of connection: | Under counter |
---|---|
H x B x T: | 305 x 280 x 175 mm |
Material: | Grilamid TR 90, POM (Hostaform C 2571) |
Length of the filter cartridge: | 248 mm | 9 3/4" |
Suitable for low pressure boilers: | Yes |
Length of the connection hoses: | approx. 800 mm |
Connection: | 3/8" union nut, Compression fitting (10 mm), NW 7,2 Quick couplings |
Scope of delivery
Scope of delivery
This Carbonit DUO-HP Basic (parallel) set contains the following parts
- one Carbonit DUO-HP (parallel) basic module with two quick couplings (DN 7,2)
- one device key
- one inlet hose kit containing:
- one flexible hose (approx. 80 cm long with straight connections)
- with an angle valve tee (3/8") on one side
- and a ball valve with nipple (DN 7,2) on the other side
- one outlet hose kit containing:
- one flexible hose (approx. 80 cm long with straight connections)
- with a ball valve with nipple (DN 7,2) on one side
- and one 90° compression fitting (10 mm) on the other side